HVAC installation is the work of fitting a new air conditioner, furnace, heat pump or a full matched system in your home. Fixr's 2026 guide puts the average installed central AC near $6,000, and its 3-ton range is $2,500 to $8,000. A new furnace averages about $4,800 and a heat pump about $8,350. The right number for your house depends on size, ductwork and equipment. Below you will find the cost drivers, how to decide between repair and replacement, what California requires and how to compare bids. To see local prices, you can request quotes from local specialists.
What is the 5,000 rule for HVAC and AC?
The 5,000 rule is a common rule of thumb, not from a manufacturer: multiply the cost of a repair by the age of your system in years. If the number is above 5,000, replacement may be the smarter spend. A $600 repair on a 10-year-old unit scores 6,000, which points toward a new system.
It is not a law, and it treats every repair the same. A second test comes from Carrier: if a repair approaches 50 percent of the cost of a new system, replacement deserves a quote. Use both together with your own situation. Is the unit still under warranty? Is your power bill climbing? Has it broken down before? One failure on a young system is different from the third repair in two summers. The page on replacement HVAC cost walks through the math with the published ranges.
When should you replace your AC unit?
Consider replacement when the system is past roughly 10 to 15 years, repairs are frequent, bills are rising or a major part such as the compressor has failed. Carrier's lifespan table lists 15 to 20 years for central AC and furnaces and 10 to 15 for heat pumps, though its text gives a wider furnace range, and it says climate, maintenance and installation quality all change that.
Carrier's guidance is to think about replacing an AC or heat pump after about 10 years, and a furnace after about 15, especially with frequent repairs or rising energy bills. Heat pumps are listed at 10 to 15 years. These are manufacturer estimates. Modesto's hot, dry summers put long run times on cooling equipment, which is one reason regular filter changes and tune-ups matter. For more on lifespan, read how long an AC lasts. If your furnace is the aging part, see furnace replacement cost.
How much does HVAC installation cost?
Fixr puts the average installed central AC near $6,000, with a 3-ton range of $2,500 to $8,000. Furnaces average about $4,800 installed and heat pumps about $8,350 (Angi and HomeAdvisor nearer $6,000). These are national figures, not Modesto quotes.
| Project | Published national range |
|---|---|
| Central AC, 3 ton | $2,500 to $8,000 (average installed near $6,000) |
| New furnace, installed | $2,800 to $7,500 (average about $4,800) |
| Heat pump, central air-source | $5,000 to $15,000 (average about $8,350) |
Sources are Fixr's installation guides. Other sizes, ductless systems and combined AC and furnace jobs vary too much for one range, so ask for them itemized. Fixr states its AC page gives no California or regional pricing, and no source for this page gave Modesto figures, so treat the table as a guide. Factors that move the price include the size of your home, the tonnage, the efficiency rating, the condition of your existing ductwork, the fuel type for a furnace and labor rates. Furnace installation labor alone is listed at $300 to $1,800. If ducts need work, see duct replacement cost. For heat pumps, read heat pump cost and furnace versus heat pump.
What does SEER mean and what does California require?
SEER is a rating of how efficiently a central air conditioner uses electricity over a season. Higher is more efficient. Since 2023 the rating is SEER2. In California (the Southwest region), split central AC under 45,000 Btu/h must meet 14.3 SEER2, and heat pumps 14.3 SEER2 and 7.5 HSPF2.
A higher SEER2 rating costs more up front and can lower your power bill, but the savings depend on how much you run the system, which in a Central Valley summer is a lot. Ask each bidder for the model number and the SEER2 rating of the equipment in the quote so you can compare like with like. A bid that gives only a brand and a tonnage is hard to judge.
The refrigerant is changing too. EPA's May 2026 final rule removed the January 1, 2026 installation deadline for most residential R-410A systems made before 2025; check EPA's Technology Transitions page and local rules. Ask what refrigerant your quote uses, since service parts and refrigerant cost differ. Refrigerant is priced by the pound and varies by source, so the quote should show pounds and price per pound.
What time of year is cheapest to replace HVAC?
No source checked for this page gave seasonal pricing, so there is no sourced "cheapest month." A common-sense view is that installers are busiest when cooling or heating demand peaks, which in Modesto means summer heat for AC and the first cold nights for furnaces. Replacing before the peak gives you time to compare bids.
If your system is still running but old, the spring or early fall shoulder seasons give you room to shop without a failed system forcing a rushed choice. July highs average about 95 F in climate data compiled by Climates to Travel, and from 2017 to 2026 Modesto logged between 12 and 45 days a year at or above 100 F, per Extreme Weather Watch (the 2026 count is incomplete). Waiting for a breakdown on a 105 F day means paying for speed. A planned replacement lets you get several written quotes and ask about rebates.
The Modesto Irrigation District has listed rebates for heat pumps and central AC in the past, but listings conflict. Confirm what is available with MID at (209) 526-7339 before relying on it. Public Utilities Code section 9610 sets which utility, MID or PG&E, serves which territory near Modesto, so confirm the utility for your address.
What happens during an HVAC installation project?
A proper job starts with sizing the system to your house, not just copying the old tonnage. Then comes removal of the old equipment, setting the new unit, connecting refrigerant lines and electrical, checking ductwork, testing airflow and charge, and a walkthrough. Permits and energy-code checks may apply.
Ask whether the bid includes a load calculation, since sizing should come from a proper load calculation, not the old tonnage. An oversized system can short cycle and fail to remove humidity, as Carrier explains. Ask about the permit as well. Stanislaus County's planning fee schedule lists HVAC and wall or floor furnace permit fees. Confirm the current amount with the county before budgeting, and ask the building department about a swap inside Modesto city limits. Title 24 requires duct sealing and testing when a duct system is new or replaced; confirm the edition for your permit, and ask who handles that.
You also need the right contractor. California requires a CSLB license for work worth $1,000 or more in labor and materials, and any installation will exceed that. Check the license at cslb.ca.gov or call 800-321-CSLB (2752), Splitting one job into smaller invoices does not get around the license requirement, so treat it as a warning sign. Quotes on this site come from independent local businesses, so verify each one. See how this works, or go back to the Modesto HVAC home page. A new system often comes with a new thermostat, so see thermostat replacement for that part of the bill.
If you are still deciding who to call, read how to judge a specialist before you accept a quote.
Questions people ask
How long does HVAC installation service take?
There is no single sourced time. Fixr lists furnace installation labor at 4 to 10 hours, and a full AC or system replacement takes longer, especially if ducts, the pad or electrical need work. Ask each specialist for a schedule in writing, and ask what happens if they find extra work once the old equipment comes out.
What should I ask before I hire someone for HVAC installation service?
Ask for their CSLB license number and check it. Ask for a written quote showing make, model, SEER2, tonnage and what is included, such as permits, duct work and removal. Ask who pulls the permit, how warranty claims work, and what the payment schedule is. Compare at least two or three bids before you pick.
Do I need to be home for HVAC installation service?
Plan on an adult being there at the start and end of the job. The crew needs access to the attic, garage or closet that holds the indoor unit and to the outdoor pad, and someone must approve changes and walk through the finished work. Power and the AC will be off for part of the day.
Is it worth upgrading to a higher SEER2 unit?
It can be, if you run your system a lot. Higher ratings cost more up front and trim electricity use, but how much you save depends on your home and habits. The legal floor for central AC in California is 14.3 SEER2. Ask for a price at the minimum and at a higher rating.
Should I replace the AC and furnace together?
Sometimes. If both are old, replacing them together can save on labor and make sure the indoor and outdoor parts match. If only one has failed and the other has years left, replacing one at a time spreads the cost. Ask the specialist to price both ways and note any warranty or matching requirements.
Read on
- AC lifespan
How long does a central AC last? Typical lifespans, what shortens them in hot Modesto summers, signs it is time to replace and what a new…
- Full HVAC replacement cost
Replacement HVAC cost in published US guides: central AC, full AC and furnace systems, California efficiency rules and quote questions.
Sources
- Fixr central AC installation guide (2026)
- Fixr new furnace installation guide
- Fixr heat pump installation guide
- Carrier, how long HVAC systems last
- U.S. Department of Energy, 2023 energy conservation standards FAQ
- EPA, Technology Transitions
- CSLB, what kind of contractor do you need
- Stanislaus County planning fee schedule
- Climate data for 1991 to 2020 compiled by Climates to Travel
Last updated
